Page 1 of 1
Procedures wont work
Posted: Mon May 21, 2018 8:53 pm
by PavlinS
Well, I have good procedures in my sim. It turns out they cost problems with loading in the simulator.
Still see on some airports DEFAULT SID after I added in the scenery the procedures on the correct folder. Now I can't do depart because of missing departure SID. That's annoying. Can someone help me?
Re: Procedures wont work
Posted: Mon May 28, 2018 12:58 pm
by V12
IMHO, You are using very fresh AIRAC procedures downloaded somewhere from internet (Don't worry, me too
).
Post example, please. I found some airports in FG with bad signed runways. And when the procedure is defined for runway 25L, but in the FG is that runway signed 25, You can't see procedure list for that runway. FG data are very old
But not all airports and its runways have defined approaches, SIDs and STARs...
Re: Procedures wont work
Posted: Fri Jun 29, 2018 4:11 pm
by PavlinS
O, they were a gift, real ones, from Navigraph.
Well, for now I am not going to use VATSIM so I do not need a solution. It was for KLAS airport. Thx for the interest, V12!
Re: Procedures wont work
Posted: Mon Jul 02, 2018 8:50 am
by V12
For KLAS there are runways 01L/R,07L/R,19L/R and 25L/R in the FlightGear data, but AIRAC procedures has definitions for 01 L/R, 08L/R, 19L/R and 26 L/R. Result is clear - You can see procedures only for 01L/R and 19L/R runways.
Re: Procedures wont work
Posted: Wed Jul 04, 2018 10:25 pm
by PavlinS
Ya, I know it already, thx. You might help with my new topic if you want.