Postby J Maverick 16 » Mon Jun 27, 2016 9:01 pm
UPDATED TO-DO LIST IN ORDER OF IMPORTANCE (deadline July 28th):
1) Implement the new autopilot "IT-AUTOFLIGHT".
2) make a whole new AP panel in the center part of the cockpit (where the current one stays).
3) work on the boom operator office (new instruments, fix the point of view in RT (makes the rear aircraft part invisible), etc. + onox)
4) work on fuel tanks and payloads (reduce available payload and add a standard load, implement fuel consumption while refueling, onox as reference).
5) improve ATA refueling (boom texture and model + code, onox model)
6) make the CDUs work properly + resize, reposition and retexture them.
7) put new radio comms under the throttle levers + TACAN instrument.
8) improve the trims.
9) add a MFD between the two CDUs which works as TCAS, systems, and other.
10) 3D engines models: UV map, smoke.
11) work on both engineer and overhead panel (improve instruments and move some from the eng to the oh).
12) Switch the "Autopilot view" to "Overhead panel view".
13) improve the magnetic compass instrument (make it fixed and place a new compass).
14) improve engines sounds.
15) add a few passenger seats to the cabin.
16) remove/move the "Rolex" in the middle of the cockpit.
17) remove/change cargo loaders (onox model)
18) implement MP dual control for co-pilot and boom operator.
19) create xml files for the liveries.
This is the lot, then we'll have a break and start on the AWACS (which will feature many similar changes so it will take less time to have a better aircraft).
Regards, Mav
Last edited by
J Maverick 16 on Wed Jun 29, 2016 2:28 pm, edited 3 times in total.
Breakin' the sound barrier every day!
Scenery designer, basic livery maker, aircraft developer (current project: F-16).
Using Thrustmaster FCS Flight Pack.
Follow me also on Instagram & Twitter @j_maverick16, Google+ and YouTube.
